Use and maintenance of automatic binding machine

2025-04-05 21:16:30

Before using the binding machine, it is necessary to check whether the photoelectric cells of the binding machine components are intact, whether the reflector is aligned and whether there is dust on it. If it is not aligned, align it in the correct position and remove the dust on it. Check whether the screws and nuts of each component are loose and tighten them in a timely manner. If there is a shortage of nails or caps, the repair personnel must be notified to handle it in a timely manner. Check if there are any foreign objects blocking the conveyor belt. If there are, they must be removed and the dust inside the conveyor belt should be blown out with compressed air.

Check if the crankshaft is short of oil. If it is, the crankshaft must be oiled using a dipping method, usually with a small stick dipped in oil and slowly dripped onto the shaft. It should not flow backwards into the conveyor belt, as it may slip and fail to retract or tighten the belt. If any abnormal phenomena are found during the startup process, such as loud noise, vibration, odor, etc., and cannot be detected by oneself, the automatic binding machine should be stopped and repair personnel should be called to handle it to avoid damage to internal parts. In addition, we also provide the use and maintenance of vacuum packaging machines, bundling machines, and shrinking machines. During the production process of strapping, due to factors such as the density of incoming materials, equipment failures, and human factors, the specifications of the strapping are unstable after manufacturing, often resulting in uneven thickness, width, and rough surface. During the packaging process, there may be issues such as inability to attach straps, tightness of straps, and jamming of straps. It directly affects the production schedule and the downtime rate of the packaging team. The usual method for handling the above is to first check whether it is due to the equipment or the straps. When confirming that it is due to the straps, if uneven thickness or width is found, it is a quality problem with the strapping straps. We need to cut off the small section that is not qualified and not use it. During the trial production, if we can fit the strap but cannot tighten it, adjust the elastic button on the binding machine until the strap meets the process standards.